Hydraulic load sensing and control devices

In order to direct the oil flow from the hydraulic pump to the equipment to be driven, load sensing and control devices, which are built up in modular construction segments, are used.

Hydraulic load sensing and control devices

Grid List

Set Descending Direction
  • HT1011

    Single step load sensing
    Single step load sensing device, 24 Volt. Gives zero or full flow rate, depending on whether a load is sensed or not. Used for e.g. bow and stern thrusters.
  • HT1012

    Dual step loading sensing
    Dual step load sensing device, 24 Volt. Gives zero, partial or full flow rate, dependant on load sensed. Used for e.g. bow and stern thrusters.
  • HT1013

    Directional control
    A 12 Volt version of this solenoid control unit is available by special order.
  • HT1014

    Directional control
    Solenoid control unit with counterbalance. For numerous applications, e.g. mast lowering or hinged radar support. 12 V version available by special order.
  • HT1019

    Control unit
    Priority valve solenoid control unit for Vetus power steering or an inboard autopilot. A 12 Volt version is available by special order.
  • HT102311

    Single step solenoid
    Control unit for anchor windlasses, with speed adjustment in both directions for optimum veer/haul chain rates. 12 V version is available by special order.
  • HT102312

    Dual step solenoid
    Control unit for anchor windlasses, with speed adjustment in both directions for optimum veer/haul chain rates. 12 V version is available by special order.
  • HT1024

    Solenoid control unit
  • HT1026

    Sub-plate for extension
    Manifold for five additional solenoid control units. Supplied with blanking plates and extension electrical connection box.

Grid List

Set Descending Direction